Most stone side tables are a top with something underneath it — a steel frame, a turned column, legs that were always the cheap part. This one has no frame at all. The top and the base are two separate blocks of beige travertine, each carved from a single piece, and the top sits on the base under its own weight.
The top is 61cm across and 15cm thick. The base is 35cm across and 43cm tall, an ovoid a little taller than it is wide, with a flat patch ground into the bottom so it does not rock. Stacked, the table stands about 58cm high: low enough to put a hand on from a sofa, high enough for a cup within reach. The two pieces come apart, so it travels up a stair in two lifts instead of one dead weight.
Travertine is not a smooth stone by nature. It forms in mineral springs, layer over layer, and the horizontal banding is the record of that, while the small pits are gas that was trapped and never left. On the top we fill only the pores that break the surface, then hone it flat; the sides keep their open texture. Every block bands differently, so the stripe width and the number of pits on your piece will not match the photo exactly.
Put it where a coffee table is too big and a stool is too small — beside a sofa, between two armchairs, next to a bed. Because the base is narrower than the top, your feet still fit under the overhang, and the 61cm surface takes a lamp, a book and a cup at once.
DIMENSIONS & CRAFT
- Size: Top 61 × 15cm / Base 35 × 43cm / Total height 58cm
- Material: Beige Travertine (Italy)
- Construction: Two separate pieces, top seats on the base
- Finish: Honed, sealed
- Lead time: 4–7 weeks production, then 5–9 weeks ocean freight
A note on care: wipe with mild soap and a soft cloth, skip vinegar and bleach, and re-seal once a year. Do that and the surface will outlast every other finish in the room.


















Calacatta Viola 




Reviews
There are no reviews yet.